If you've mopped a floor using a Swiffer WetJet and now want to spot clean with Clorox bleach, it's important to exercise caution as mixing certain cleaning products can be dangerous. In this case, you should not mix bleach with any product that contains ammonia or acids, as it can create toxic fumes.
Since Swiffer WetJet contains cleaning agents and it's unclear if it contains any ammonia or acids, it's best to err on the side of caution and not combine it with bleach. It's recommended to wait at least 24 hours after using the Swiffer WetJet before applying bleach to the same area.
If you need to spot clean with bleach, here's a safer approach:
Wait for at least 24 hours after using the Swiffer WetJet to ensure any residues have dried or dissipated.
Thoroughly rinse the area you want to spot clean with water to remove any residual cleaning solution from the Swiffer WetJet.
Apply the bleach to the desired spot by using a clean cloth or sponge. Make sure to follow the instructions on the bleach product for proper dilution and application.
Allow the bleach to sit on the spot for the recommended contact time specified on the bleach product label.
Rinse the area thoroughly with water to remove the bleach.
Always ensure proper ventilation when using bleach, and follow the safety guidelines on the product label. It's advisable to wear gloves and protect your eyes and skin while handling bleach.
Remember, if you're uncertain about the compatibility of cleaning products or have concerns about using bleach, it's best to consult the product labels or contact the manufacturers for specific guidance.