Using a Rug Doctor carpet cleaner is relatively straightforward. Here's a step-by-step guide to help you:
Preparation:
- Start by vacuuming the carpet thoroughly to remove loose dirt and debris.
- Remove any furniture or obstacles from the area you plan to clean.
- If there are any stains or heavily soiled areas, pre-treat them using a suitable carpet stain remover or the recommended Rug Doctor cleaning solution.
Filling the machine:
- Locate the clean water tank on the Rug Doctor machine. It is typically on the bottom front of the unit.
- Lift the tank's lid and fill it with hot water. Be sure to use hot water as it helps improve the cleaning effectiveness.
- Add the appropriate amount of Rug Doctor carpet cleaning solution to the tank according to the instructions provided on the cleaning solution bottle. Usually, you'll need to pour the solution into a designated chamber or follow the indicated measuring lines on the tank.
Assembling the machine:
- Attach the clean water tank back onto the Rug Doctor machine, ensuring it is securely in place.
- If applicable, insert the upholstery or carpet cleaning attachment if you need to clean stairs, furniture, or other non-floor surfaces.
Cleaning process:
- Plug in the Rug Doctor machine and turn it on.
- Begin cleaning by squeezing the machine's trigger or pressing the cleaning solution dispenser button located on the handle. This will release a mixture of water and cleaning solution onto the carpet.
- Slowly push the machine forward, allowing the brushes and suction to agitate and extract dirt from the carpet. Continue moving the machine in straight lines, overlapping each pass slightly.
- Once you've completed a forward pass, release the trigger or stop the solution dispenser and pull the machine back over the same area without dispensing any solution. This will allow the machine to suction up the dirty water and excess moisture.
- Repeat this forward and backward motion, working in small sections until you have cleaned the entire carpeted area.
Post-cleaning:
- After completing the cleaning process, allow the carpet to dry thoroughly. It's best to ventilate the room and use fans to expedite the drying process.
- Empty and rinse the dirty water tank of the Rug Doctor machine. Rinse the tank with clean water until the water runs clear.
Note: Always read and follow the instructions provided with your specific Rug Doctor model and the recommended cleaning solutions. Different models may have slight variations in operation, so it's important to refer to the user manual for detailed instructions.
Additionally, Rug Doctor offers customer support services, so if you have any specific questions or concerns about using their carpet cleaner, don't hesitate to reach out to their customer service for assistance.