The process of resetting an electric submeter may vary depending on the specific model and manufacturer. However, I can provide you with some general guidelines that may help:
Locate the submeter: The submeter is typically installed near the main electrical panel or where the electrical service enters your property. It may be housed in a separate box or panel.
Identify the reset button: Look for a reset button or switch on the submeter. It might be labeled as "Reset," "RST," or have a similar designation. In some cases, the reset button may be recessed and require a small tool, like a paperclip or a pen, to press it.
Disconnect power (if applicable): Before resetting the submeter, it's important to ensure your safety. If the submeter has its own power supply or breaker, switch it off or disconnect the power by turning off the corresponding breaker in the main electrical panel.
Press and hold the reset button: Once you have ensured that the power is disconnected, press and hold the reset button on the submeter. The duration for holding the button may vary, so consult the submeter's user manual or contact the manufacturer for specific instructions.
Restore power (if applicable): After holding the reset button for the required time, restore power to the submeter by turning on the breaker or reconnecting the power supply.
Observe the submeter: After resetting, observe the submeter to see if it returns to its default or initial state. It may take a few moments for the submeter to recalibrate and display accurate readings.
It's important to note that the above steps are general guidelines and may not be applicable to all submeters. To ensure the correct reset procedure for your specific submeter model, it's recommended to refer to the user manual provided by the manufacturer. If you're unsure about the process or have any concerns, it's advisable to consult a qualified electrician for assistance.