To troubleshoot and resolve an AE error code on an LG dishwasher, you can follow these steps:
Power off the dishwasher: Turn off the dishwasher and unplug it from the power source. Wait for a few minutes to allow the electronics to reset.
Check the water supply: Ensure that the water supply to the dishwasher is properly connected and turned on. Make sure there is no kink or blockage in the water supply hose.
Clean the filters: Remove the filters from the bottom of the dishwasher and clean them thoroughly. Clogged filters can restrict water flow and trigger error codes.
Inspect the drain hose: Check the drain hose for any kinks, clogs, or damage. Straighten out any kinks and remove any clogs or debris from the hose.
Reset the dishwasher: Plug the dishwasher back in and turn it on. Press and hold the Start button for approximately 3 seconds to reset the dishwasher's control board.
Run a test cycle: Close the dishwasher door and select a short test cycle. Start the cycle and observe if the error code reappears. If the error code persists, proceed to the next step.
Contact LG support: If the above steps don't resolve the issue, it's recommended to contact LG customer support or refer to the user manual for specific troubleshooting steps related to the AE error code. They can provide further assistance and guidance in resolving the problem.
Remember to exercise caution when working with electrical appliances and, if necessary, consult a professional technician for advanced troubleshooting or repairs.