To change the dryer belt on a Roper dryer, follow these step-by-step instructions:
Before you begin: Unplug the dryer from the power outlet to ensure safety during the process.
Tools you might need:
- Screwdriver (type depends on your dryer model)
- Nut driver or socket set
- Putty knife or a flat-head screwdriver
- New dryer belt (Make sure to purchase the correct belt for your specific Roper dryer model. You can find this information in the dryer's user manual or on the manufacturer's website.)
Step-by-step process:
Access the dryer's interior: Open the dryer door and remove the lint filter. Look for screws or clips around the lint filter opening that secure the top panel of the dryer to the front panel. Use a screwdriver or a nut driver to remove these screws or clips.
Lift the top panel: Once the screws/clips are removed, lift the top panel of the dryer. Depending on your model, you may need to use a putty knife or flat-head screwdriver to release the spring clips that secure the top panel to the front panel. Slide the putty knife or screwdriver along the seam between the top and front panels and gently pry to release the clips.
Remove the front panel: With the top panel lifted, you should see screws or retaining clips that secure the front panel to the sides of the dryer. Remove these screws or unclip the front panel from the sides and carefully lift it away from the dryer. Take care not to damage any wiring connected to the front panel.
Release the old belt: Once the front panel is removed, you will have access to the dryer's drum and motor area. The old belt should be wrapped around the drum and looped over the motor and idler pulley. Take note of the belt's configuration before removing it. If necessary, take a picture or make a drawing to help you remember how the belt is routed.
Install the new belt: Place the new dryer belt around the drum in the same configuration as the old one. Refer to your earlier notes or pictures for guidance. The ribbed side of the belt should be against the drum.
Route the belt: Thread the belt through the idler pulley and around the motor pulley, creating tension on the belt. Make sure the belt is sitting on the pulleys correctly and follows the correct path.
Reassemble the dryer: With the new belt in place, reattach the front panel to the sides of the dryer and secure it with screws or clips. Lower the top panel back into place and secure it with screws or clips as well.
Test the belt: Before fully reassembling the dryer, manually rotate the drum by hand to ensure the belt is properly aligned and seated on the pulleys.
Reinstall the lint filter and plug the dryer in: Slide the lint filter back into its slot and plug the dryer back into the power outlet.
Test the dryer: Turn on the dryer and run a short cycle to confirm that the belt is working correctly. Listen for any unusual noises or misalignment issues. If everything seems fine, you've successfully replaced the dryer belt.
Remember, these instructions are general guidelines, and the specific steps might vary depending on your Roper dryer model. Always refer to your dryer's user manual for model-specific instructions and safety precautions. If you're unsure or uncomfortable with the process, consider seeking help from a professional appliance repair technician.