If your AEG 8000 series washer/dryer is continuously pumping during a drying cycle, it may indicate a potential issue with the appliance. Here are a few possible reasons for this behavior:
Clogged or blocked lint filter: The continuous pumping might occur if the lint filter is clogged or blocked. A dirty or obstructed filter can restrict airflow, causing the appliance to pump air continuously to maintain proper drying conditions. Make sure to clean the lint filter regularly as per the manufacturer's instructions.
Ventilation problems: Insufficient ventilation can lead to the continuous pumping of air by the washer/dryer. Check the dryer's exhaust vent and ensure it is not blocked or restricted. Obstructions in the venting system can hinder the proper flow of air, causing the appliance to work harder to dry the clothes.
Sensor or control board malfunction: Modern washer/dryers often utilize sensors and control boards to monitor and regulate drying conditions. If one of these components malfunctions, it may cause the appliance to misinterpret the drying status and continuously pump air. In such cases, contacting a qualified technician or the manufacturer's customer support for assistance is recommended.
Overloading the appliance: Overloading the washer/dryer beyond its recommended capacity can disrupt the drying process and result in continuous pumping. Ensure that you are not exceeding the maximum load capacity specified by the manufacturer to allow for proper airflow during drying.
It's important to note that specific troubleshooting steps may vary based on the model and features of your AEG 8000 series washer/dryer. Consulting the appliance's user manual or reaching out to the manufacturer's customer support will provide you with detailed instructions tailored to your particular model.